![]() ![]() While a Graver for example is limited for the most part to OD turnings, its capabilities/accuracy is very limited when compared to a properly designed and equipped machine tool lathe with lathe tooling mounted in a tool post. are designed as machine tool Lathes but are not created equal in regard to capabilities. Lathes such as Sherline, Taig, Cowells etc. For most people, Graver skills can take years to develop. However, what was not mentioned is that when using a Graver, what comes off of the lathe for the most part is determined by the skills of the person using the Graver and not so much the Lathe itself. If you compare a Taig Lathe to other lathes where a Graver is used, then Johns comments are right on. If it is only to be used occasionally with the most basic of machining practices, then just about anything will do. To make a long story short, it depends on you, your standards and requirements for a Lathe. The quick answer to your question is "No". USA, The Nicolas G.This is a complicated question that requires more considerations than is practical to discuss here.USA, NAWCC Watch and Clock Traveling Workshop Program.USA, NAIOSW - The North American Institute of Swiss Watchmaking, Dallas, TX.USA, Lititz Watch Technicum, Lititz, PA.USA, Jewelry & Watch Repair School of New England, Manchester, CT, video-guided distance learning programs.USA, Gem City College School of Horology, Quincy, IL.USA, Emily Griffith Technical Institute, Denver, CO.USA, Edward H Stone's Clockmaking Classes, Bowie, MD, one week classes.USA, David J LaBounty, Mitchell, NE, live internet classes.USA, Career Preparation Center Horology Department, Sterling Heights, MI.USA, Bishop State Community College, Mobile, AL. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |